The ASGK990 Series Fixed-Length Support Beam is a robust chassis-mounted support solution designed for use in conjunction with ASGK990 Series Hinged Sideguard Legs and rails

Ideally suited to refrigerated vehicles, tippers and applications where conventional hinged legs cannot be mounted, it provides a durable and practical alternative for commercial vehicle sideguard installations

Designed to accommodate standard chassis widths, the support beam is supplied with compatible mounting brackets and optional 5mm and 10mm extension plates, allowing greater flexibility during installation

Finished with an Armour-Tech 600 (AT600) surface coating, the support beam offers enhanced corrosion protection and has been tested to withstand 600 hours of salt spray exposure

When used in conjunction with ASGK990 Series hinged sideguard legs and rails, and installed in accordance with UNECE Regulation No. 73, the system complies with the applicable mandatory requirements of Whole Vehicle Type Approval

Key Features & Benefits:

• Fixed-Length Design: Provides a robust chassis-mounted support solution for compatible sideguard systems
• Compatible System: Designed exclusively for use with ASGK990 Series Hinged Sideguard Legs and rails
• Versatile Applications: Ideally suited to refrigerated vehicles, tippers and installations where conventional hinged legs cannot be accommodated
• Chassis Compatibility: Designed to suit standard chassis widths
• Extension Plates: 5mm and 10mm plates available to assist with installation
• Durable Construction: Robust design for demanding commercial vehicle applications
• Advanced Surface Protection: Armour-Tech 600 (AT600) coating, tested to 600 hours of salt spray exposure
• Mounting Configuration: One ø12.5mm hole and one 20.0mm × 12.5mm slot
• Fixings Required: Two ø12.5 mm high-tensile bolts required for installation
• Approval Documentation: E-approval certification and comprehensive mounting instructions available upon request

Important Installation Requirements - Maximum Recommended Beam Spacing

• Without infill panels: Maximum recommended beam spacing is 2000mm
• With infill panels: Maximum beam spacing must be reduced to 1500mm
• The addition of infill panels significantly increases the loads imposed on the sideguard system. Excessive beam spacing may increase stresses within the steel members, accelerate fatigue and compromise the structural integrity of the installation over its service life

Compliance with these spacing requirements is essential to maintaining the structural performance and safety of the system

Compatibility & Additional Information:

Please note that the hinged leg is not included with the support beam. Compatible ASGK990 Series Hinged Sideguard Legs must be purchased separately

For further information, approval documentation or installation guidance, please refer to the ASGK990 Series Hinged Sideguard Legs